Only Cub Cadets

PLEASE PATRONIZE OUR SPONSORS!

CC Specialties R. F. Houtz and Sons Jeff in Pa.

P&K Cub Cadet Machtech Direct

Cub Cadet Parts & Service


If you would like to help maintain this site & enhance it, feel free to donate whatever amount you would like to!




Attention Guest, We have turned off the forum to guest. This is due to bots attacking the site. It is still free to register.

-->
Go Back   Only Cub Cadets > Cub Cadets > IH Cub Cadet Tractors (GT)
Reload this Page Very slow cranking
Register FAQ Calendar

Notices

Reply
Page 1 of 2 1 2
 
Thread Tools Display Modes
  #1  
Old 07-03-2022, 11:08 PM
joey7478 joey7478 is offline
New Member
  
Join Date: Jul 2022
Location: OH
Posts: 25
Default Very slow cranking
I rebuilt my k241. It has new piston and has been bored to .10 over. It also has new, points, rings, rod, spark plug, carb, valves, battery, and I rebuilt starter generator. I set the valves .018 exhaust, and .008 intake. It won't start because it cranks so slow. It will run battery down with just a few cranks. I unhooked the drive shaft and it did start once and ran several minutes but when it died it wouldn't restart. It only cranked a couple time and the battery was run down and was cranking so slow. what wrong with this tractor?
Reply With Quote
  #2  
Old 07-04-2022, 04:54 AM
1711Cub's Avatar
1711Cub 1711Cub is offline
Senior Member
  
Join Date: May 2020
Location: Elkland, PA
Posts: 752
Exclamation
Does it turn easily by hand? Possibly sounds like a defective battery, starter, or tight clearances in the engine.
__________________

582, 682, 782, 782D, 1282, 1050, 1210 x 2, 1711, and 1811
Reply With Quote
  #3  
Old 07-04-2022, 08:14 AM
R Bedell R Bedell is offline
Founding Member
  
Join Date: Mar 2007
Location: Michigan
Posts: 13,684
Default
First, welcome to OCC........

As we have heard of this hundreds of times, I would check your Battery first. Have it charged and "load tested". If the battery tests good, use it. If not, replace it.

Next, check both your Battery Cables. Check both ends, and makes sure that they are "clean, bright, and tight".

Since you make NO mention of the model of tractor you are working on, general information is the best we can offer.
__________________
[B]Roland Bedell[/B]

CC Models: 100, 105, 1450, 782, (2) 784, & 2072

[SIZE="4"][B][COLOR="Red"]Buy:[/COLOR][COLOR="Blue"] Made in the USA[/COLOR][/B] [/SIZE]:American Flag 1:
Reply With Quote
  #4  
Old 07-04-2022, 09:42 AM
Billy-O's Avatar
Billy-O Billy-O is offline
Grand Member
  
Join Date: Jul 2012
Location: New Jersey
Posts: 1,963
Default
What Roland suggested!

Sometimes the starter/generator belt needs tightening.

The other thing you can check is make sure you PTO is disengaged if you have an PTO powered implement hooked up.
__________________
Two 125's and a 124 all with 42" decks
Plow blade
#2 Cart
QA36 snowthower
Reply With Quote
  #5  
Old 07-05-2022, 06:30 AM
crazycubtrio crazycubtrio is offline
Member
  
Join Date: Aug 2017
Location: Indiana
Posts: 87
Default
A couple of things come to mind mechanically. If this was just rebuilt was the crankshaft end play properly set with the correct number ( thickness) of gaskets? Also did the rod cap get installed the right way? Don’t mean any disrespect but I’ve seen both these problems cause these little engines crank over really hard.
Reply With Quote
  #6  
Old 07-05-2022, 08:20 AM
finsruskw finsruskw is offline
Grand Member
  
Join Date: Mar 2013
Location: Iowa
Posts: 3,302
Default
What tractor is this 10 horse in??
Reply With Quote
  #7  
Old 07-05-2022, 07:37 PM
joey7478 joey7478 is offline
New Member
  
Join Date: Jul 2022
Location: OH
Posts: 25
Default
Quote:
Originally Posted by R Bedell View Post
First, welcome to OCC........

As we have heard of this hundreds of times, I would check your Battery first. Have it charged and "load tested". If the battery tests good, use it. If not, replace it.

Next, check both your Battery Cables. Check both ends, and makes sure that they are "clean, bright, and tight".

Since you make NO mention of the model of tractor you are working on, general information is the best we can offer.
Its a cub cadet model 105
Reply With Quote
  #8  
Old 07-05-2022, 07:41 PM
joey7478 joey7478 is offline
New Member
  
Join Date: Jul 2022
Location: OH
Posts: 25
Default
Quote:
Originally Posted by crazycubtrio View Post
A couple of things come to mind mechanically. If this was just rebuilt was the crankshaft end play properly set with the correct number ( thickness) of gaskets? Also did the rod cap get installed the right way? Don’t mean any disrespect but I’ve seen both these problems cause these little engines crank over really hard.
That what i'm thinking need to tear it apart and see what up. Thanks!
Reply With Quote
  #9  
Old 07-05-2022, 07:44 PM
joey7478 joey7478 is offline
New Member
  
Join Date: Jul 2022
Location: OH
Posts: 25
Default size
Quote:
Originally Posted by finsruskw View Post
What tractor is this 10 horse in??
It's a 105
Reply With Quote
  #10  
Old 07-05-2022, 08:10 PM
ol'George's Avatar
ol'George ol'George is offline
Grand Member
  
Join Date: Oct 2009
Location: MI
Posts: 6,932
Default
Answer post #2 question, does it turn normally by hand with the spark plug out ?
Reply With Quote
Reply
Page 1 of 2 1 2

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 09:34 PM.

www.onlycubcadets.net - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.

Cub Cadet is a premium line of outdoor power equipment, established in 1961 as part of International Harvester. During the 1960s, IH initiated an entirely new line of lawn and garden equipment aimed at the owners rural homes with large yards and private gardens. There were a wide variety of Cub Cadet branded and after-market attachments available; including mowers, blades, snow blowers, front loaders, plows, carts, etc. Cub Cadet advertising at that time harped on their thorough testing by "boys - acknowledged by many as the world's worst destructive force!". Cub Cadets became known for their dependability and rugged construction.

MTD Products, Inc. of Cleveland, Ohio purchased the Cub Cadet brand from International Harvester in 1981. Cub Cadet was held as a wholly owned subsidiary for many years following this acquisition, which allowed them to operate independently. Recently, MTD has taken a more aggressive role and integrated Cub Cadet into its other lines of power equipment.

This website and forum are not affiliated with or sponsored by MTD Products Inc, which owns the CUB CADET trademarks. It is not an official MTD Products Inc, website, and MTD Products Inc, is not responsible for any of its content. The official MTD Products Inc, website can be found at: http://www.mtdproducts.com. The information and opinions expressed on this website are the responsibility of the website's owner and/or it's members, and do not represent the opinions of MTD Products Inc. IH, INTERNATIONAL HARVESTER are registered trademark of CNH America LLC

All material, images, and graphics from this site are the property of www.onlycubcadets.net. Any unauthorized use, reproductions, or duplications are prohibited unless solely expressed in writing.

Cub Cadet, Cub, Cadet, IH, MTD, Parts, Tractors, Tractor, International Harvester, Lawn, Garden, Lawn Mower, Kohler, garden tractor equipment, lawn garden tractors, antique garden tractors, garden tractor, PTO, parts, online, Original, 70, 71, 72, 73, 76, SO76, 80, 81, 86, 100, 102, 104, 105, 106, 107, 108,109, 122, 123, 124, 125, 126, 127, 128, 129, 147, 149, 169, 182, 282, 382, 482, 580, 582, 582 Special, 680, 682, 782, 782D, 784, 800, 805, 882, 982, 984, 986, 1000, 1015, 1100, 1105, 1110, 1200, 1250, 1282, 1450, 1512, 1604, 1605, 1606, 1610, 1615, 1620, 1650, 1710, 1711, 1712, 1806, 1810, 1811, 1812, 1912, 1914.